Saturday, 23 November 2013

VOLTAGE STABLISER USING DC MOTOR CONTROL

The aim for the development of this project is to stabilize the voltage across the potentiometer by controlling the speed and direction of the motor. Motor is attached with a potentiometer to regulate the voltage across it with the regulated speed of the motor. The potentiometer is further connected to the microcontroller (PIC18f542). There are several methods for controlling the speed of DC motors here we used feedback technique of voltage from the potentiometer. One simple method is to add series resistance using a rheostat. As considerable power is consumed in the rheostat, this method is not economical. Another method is to use a series switch that can be closed or opened rapidly. This type of control is termed as chopper control. The PWM based chopper circuit smoothly controls the speed of general purpose DC motor.
A voltage set point is fixed for the output required and it is stablelized   by controlling speed of the motor after implementing the Pulse Width Modulation technique using microcontroller. As the voltage across the motor is varied using the potentiometer  the  microcontroller  ill make the voltage to be pull up or pull down in order to maintain the set point this is done by controlling speed of motor.

To eliminate the error and to increase the response Proportional Integral controller is used. The micro controller receives the voltage signal form the potentiometer convert the analog signal to digital using integrated ADC then find out error compensate it using PI and then calculate the desired PWM to maintain the speed. The direction of the motor is controlled by the H-Bridge which depends upon the duty cycle of the applied voltage.

No comments:

Post a Comment